Add-on card

Shop Forums ThermIQ in english Wishlist Add-on card

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #5503
    jarno.makinen
    Participant

    Hi,

    I have this add-on card to set temperature for floor in shower room. It would be nice to see also it’s parameters in Thermiq.

    If they are already present, then I have not found them. I have installed Thermiq betveen extra card and mainboard as instructed.

    -jarno

    #5724
    admin
    Participant

    I don’t have any of these add on cards available nor any experience with them.

    You could try and see if you see a change in any of the unspecified registers in the address map that maps your setting. If that’s not the case then ThermIQ can’t do much about it since it only has access to the main computers registermap.

    #5725
    jarno.makinen
    Participant

    Hi,

    It seems to be called ‘curve 2’. It is present in register menu and in register display.

    There areCurve 2, Curve 2 min and Curve 2 max. I think that they call it swimming pool heating.

    So basicly I would like to see this Curve 2 also in graphs.

    -jarno

    #5726
    admin
    Participant

    In general it’s easy to add or remove a value from the graphs but the registers Curve 2, min, max are all writable register to store a fixed setting and would present a flat line in the graphs. See if the value in STATUS1, STATUS2 or STATUS3 could be connected to your card.

    #5727
    jarno.makinen
    Participant

    Hi,

    I probably mixed something. The value is already there and it is called:

    Reg # Description Value Unit

    11 Supplyline temp., shunt 38 C

    and the other one is:

    15 Supplyline target temp., shunt 37 C

    -jarno

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.